OEM Navigation Dual Video Input Interface Module With Wiring Harness

To view this page ensure that Adobe Flash Player version 9.0.124 or greater is installed.

Please login or register to make a comment!

IMPORTANT NOTE: Technical support on this product is only available via e-mail . Before submitting a technical support e-mail please thoroughly read through this installation guide and double check your installation. If you have a technical question please send an e-mail to support@navvideo.com .

Technical support e-mails will be returned within 2 business days. NV_RGB3_X OEM Navigation Dual Video Input Interface Module With Wiring Harness Nav Video Installation Guide. © 2009 2 Pre-Installation Disclaimer: By purchasing and installing our products, you agree that NAV VIDEO Inc., its employees and affiliates cannot be held responsible for any accidents, tickets, misuse of products or damage caused to your vehicle.

The driver must always keep their eyes and attention on the road at all times. Our products are intended for passenger entertainment and off-road use. In some states it is illegal to have a TV viewable by the driver while the vehicle is in motion, please obey your state laws.

In addition it is your responsibility to provide this disclaimer to any party that may purchase your NAV VIDEO navigation interface from you, in or out of your vehicle. NAV VIDEO cannot be held responsible for discrepancies, or inconsistencies that may occur due to vehicle manufacturing ... more. less.

changes. Please adhere to all state and federal laws when operating your video interface. RGB Module Wiring Diagram The NV_RGB3_X Video Interface has a number of connections and controls on the module, they are outlined below: NAVI IN RGB Video Input to allow the addition of an aftermarket navigation unit that has an RGB output V1 IN Composite video input for any video device V2 IN Composite video input for any video device RV IN Composite video input for aftermarket backup camera video device. Will trigger when 12V DC is applied on reverse line. V OUT Will output video from V1, V2 or RV depending on which is currently selected. NAVI IN 3 RGB OUT These connectors is where the OEM wiring T-harness connects to. MODE Where the external black video switching button connects to. This button will toggle between the various inputs. RED WIRE 12V DC Input BLACK WIRE Ground GRAY WIRE Reverse trigger. When 12V DC is applied to this wire, AV2 will automatically be displayed on the screen. This is often used for a reverse camera setup. ORANGE WIRE I-DRV CAN Control. Not used Nav Video Installation Guide. © 2009 3 General Installation Instructions: " Turn your vehicle off and disconnect the power (if possible) " Remove LCD screen / radio assembly from dash. " Find OEM harness that matches up with the T harness provided. PLEASE NOTE, some Nissan vehicles will have TWO identical connectors, one at the radio, one at the LCD screen (often hidden) the module needs to connect to the LCD screen connector, not the radio one! " Unplug the OEM connector from behind the LCD screen and connect it to the inverted side of the connector on our wiring harness. " Plug the connector from our wiring harness into the location that the OEM connector was unplugged from behind the LCD. " Connect appropriate wires and video sources as described in the above diagram. " Reconnect power (if applicable) and turn vehicle on and test the module video switching with the remote. " Re-assemble the dash and put the LCD screen back into place. The image to the left shows an installation into an Infiniti FX 35 / 45, however the install is very similar for any Nissan or Infiniti Vehicle. Nav Video Installation Guide. © 2009 4 Remote Control Instructions:

less